Fault Code List
Displayed on Display Window Fault Description
"F01" Water inflow fault
"F03" Drainage fault
"F13" Door lock fault
"F14" Door unlock fault
"F24" Overflow or too much foam
Other fault code "F04-F98" Electronic module fault
"Unb" Imbalance alarm
a. "F01" Displayed on Screen
The tap is fully open and has enough water pressure.
Whether the water inlet pipe is knotted or not.
Whether the filtering net of the water inlet pipe is blocked or not .
Whether the water pipe is frozen or not.
Press the "Start/Pause" key after the fault is removed.
If the fault occurs again, please contact the After-Sales Service (see A
er-Sales
Service).
b. "F03" Displayed on Screen
The washer is not emptied. The washer stops the program being run. Shut down the
machine and disconnect the power supply. Check:
Whether the drain pipe is knotted or not.
Whether the filter in the drain pump is blocked or not .
IMPORTANT: Ensure that the water has cooled before draining the appliance.
Whether the drain hose is frozen up.
Plug in the appliance again.
Select and start the "Spin" program or push the "Start/Pause" button for at least
3 seconds and restart the desired program.
If the fault occurs again, please contact the After-Sales Service (see "After-Sales
Service").
18
To Next Page
Loading...
