Need help?Do you have a question about the PoLabs PoKeys57CNC and is the answer not in the manual?
General| PWM Outputs | 8 |
|---|---|
| Encoder inputs | 4 |
| Stepper motor outputs | 4 |
| PoNET devices support | Yes |
| Communication Interfaces | USB, Ethernet |
| USB interface | Yes |
| Ethernet interface | Yes |
| Supported CNC software | Mach3, Mach4 |
Lists essential hardware components required for setting up the CNC system.
Instructions for connecting stepper motor controllers to the PoKeys57CNC.
Instructions for wiring the emergency stop switch.
Connecting logical level signals (CMOS/TTL) to PoKeys57CNC.
Wiring active high and active low optocoupler inputs.
Step-by-step guide for establishing a USB connection.
Step-by-step guide for establishing an Ethernet connection.
Configuring Mach4 for motors and axis mapping.
Loading a G-code file and starting the CNC operation.
To Next Page