Do you have a question about the Polar Electro Breeze Deluxe and is the answer not in the manual?
Brand | Polar Electro |
---|---|
Model | Breeze Deluxe |
Category | Air Conditioner |
Language | English |
Use the cooler only as described; other uses void warranty and may cause injury.
Avoid immersing unit, plug, or cord in water; do not use near bathtubs or pools.
Children must be supervised; the product is not a toy. Turn unit OFF before unplugging.
Do not operate with a damaged cord or plug. Damaged cords must be replaced by qualified personnel.
Ensure adequate ventilation around the unit; do not cover grill, operate near curtains, or place on uneven surfaces.
Never install or store where subject to heat sources, direct sunlight, excessive dust, or lack of ventilation.
Diagram illustrating key components like control panel, louvers, outlets, filters, and water tank.
Details voltage, power, maximum water capacity, weight, and dimensions of the unit.
Turns the unit ON/OFF from standby mode. Remove connector from power source for shutdown.
Sets fan speed; defaults to Medium, then Low. Press key to cycle through available speed settings.
Activates evaporative cooling; requires cool water and ice blocks for best results.
Enables automatic left-to-right air vent sway for 120 degrees air flow.
Set desired operation time from 0.5-7.5 hrs. Select Normal, Natural, or Sleep modes.
Use cool water, do not fill past MAX line. Unplug before removing or filling the tank.
Clean with mild soap and water, air dry completely. Empty water and ice blocks before long-term storage.
Always switch off and unplug before cleaning. Do not use harsh detergents or solvents.
Dust surfaces with a soft duster. Wipe parts with a damp, mild soapy cloth. Dry thoroughly.
Remove and wipe or vacuum clean the cover. Dust the inner filter gently. Replace correctly.
Install the 4 castor wheels by threading them clockwise into the base holes using the provided wrench.
Fill the water tank with clean, cold water, ensuring it does not exceed the 'MAX' level indicator.
Avoid running evaporative cooler mode on humid days to prevent mould build-up on cooling pads.
Submerge filter in lemon juice and water, gently brush to remove mould, then rinse and dry.