53
OPERATION
Pre-Operation Inspection
Fuel/Water Separator
The fuel/water separator is located either
under the front compartment door behind
the storage bucket on t he starboard side or
inside the engine compartment. Inspect
the separator only w hen the watercraft is
out of the water.
1.Deck
2.Fuel/Water Separator
NOTE: The fuel/water separator is i ntegral to the fuel pump module
on Direct Injected models. It is not serviceable.
1. Visually inspect the fuel/water separator bowl (1).
If water is present at the bottom of the bowl, it will
appear as a clear liquid.
2. Turn off the fuel valve and remove the bowl by
turning it counterclockwise. NOTE: Use care to
avoid spilling fuel when removing the bowl. Wipe
up any spills immediately with a shop towel.
3. Empty the bowl and dispose of the fluid properly.
Follow all gasoline handling precautions as outlined
on page 44.
4. Re-install the separator bowl, making sure the o-ring
is in place. Hand tighten securely.
1
2
1
To Next Page
Loading...