Polaris 800 RMK 2011 User Manual

89
MAINTENANCE
Lights
When servicing a halogen lamp, avoid touching the lamp with bare fin-
gers. Oil from your skin leaves a residue, causing a hot spot that will
shorten the life of the lamp. If fingers do touch a lamp, clean it with
denatured alcohol.
Headlight Lamp Replacement
1. Peel back the foam shield covering the headlight assembly.
2. Remove the wire harness connector from the back of the headlight.
3. Grasp the bulb housing and turn it counter-clockwise to remove the
bulb.
4. Apply dielectric grease to the socket and install the new bulb.
Rotate the bulb 1/4 turn clockwise to secure it.
5. Reinstall the connector to the back of the headlight.
6. Secure the foam shield.
Taillight/Brake Light Replacement
The taillight assembly is not serviceable. If the light fails to operate
properly, replace the entire taillight assembly.

Polaris 800 RMK 2011 Specifications

General

Engine Type	Liberty
Displacement	795 cc
Track Length	155 in
Track Width	15 in
Track Height	2.4 in
Fuel Capacity	11.5 gal
Bore x Stroke	85 mm x 70 mm
Starter	Electric
Drive Clutch	P-85
Driven Clutch	Team LWT
Height	48 in
Front Travel	9 in
Rear Travel	16 in
Ski Type	Gripper
Carburetion	Mikuni