5. Disconnect the red (positive) battery cable last.
6. Lift the battery out of the battery compartment. Be careful not to tip a
conventional battery sideways, which could spill electrolyte.
NOTICE
If electrolyte spills, immediately wash it off with a solution of one tablespoon
baking soda and one cup water to prevent damage to the vehicle.
BATTERY INSTALLATION
Using a new battery that has not been fully charged can damage the battery and
result in a shorter life. It can also hinder vehicle performance. Follow the battery
charging instructions on page 75 before installing the battery.
1. Ensure that the battery is fully charged.
2. Place the battery in the battery holder.
3. With conventional batteries, install the battery vent tube (sealed batteries do
not have a vent tube). The vent tube must be free of obstructions and
securely installed. Route the tube away from the frame and vehicle body to
prevent contact with electrolyte.
WARNING
Battery gases could accumulate in an improperly installed vent tube and cause
an explosion, resulting in serious injury or death. Always ensure that the vent
tube is free of obstructions and is securely installed as recommended.
4. On conventional batteries, coat the terminals with dielectric grease or
petroleum jelly.
5. Connect and tighten the red (positive) cable first.
73
MAINTENANCE
To Next Page
Loading...
Need help?
General
