75
MAINTENANCE AND LUBRICATION
Vehicle Immersion
CAUTION
If your vehicle becomes immersed, major engine damage can
result if the machine is not thoroughly inspected. Take the
vehicle to your dealer before starting the engine.
If it’s impossible to t ake your ATV to a dealer before starting it, follow
the steps outlined below.
1. Move the ATV to dry land or at the
very least, to water below the footrests.
2. Check the airbox for any water and
dry it if water is present.
3. Turn the fuel valve off.
4. Remove the spark plug.
5. Loosen the carburetor drain screw (1).
6. Turn the engine over several times
using the electric start.
7. Dry the spark plug and reinstall, or
replace it with a new plug.
8. Tighten the carburetor drain screw.
9. Turn the fuel valve on.
10. Attempt t o start the engine. If necessary,
repeat the drying procedure.
11. Take the ATV to your dealer for service as soon as possible,
whether you succeed in starting it or not.
NOTE: If water has been ingested into the transmission, follow the
procedure on page 77 for drying the CVT.
1
To Next Page
Loading...
Need help?
General
