154
Maintenance
Handlebar Adjustment
The handlebars can be adjusted for rider preference.
1. Remove the pod to access the handlebar bolts.
Loosen the four bolts.
2. Adjust the handlebar to the desired height. Be sure
the handlebars do not hit the gas tank or any other
part of the vehicle when turned fully to the left or
right.
3. Lightly tighten each bolt equally to prevent uneven
gaps in the block. Torque the bolts to 7.3 ft. lbs. (10
Nm).
WARNING
Improper adjustment of the handlebars or incorrect torquing of the adjuster block tightening bolts
can cause limited steering or loosening of the handlebars, resulting in loss of control and possible
serious personal injury or death. Follow the adjustment procedures exactly, or see your Polaris
dealer for service.
Bolts
To Next Page
Loading...
