25
FEATURES AND CONTROLS
Brake Pedal
Depress the brake pedal to slow or stop the
vehicle. Apply the brakes while starting the
engine.
Throttle Pedal
Push the pedal down to increase engine speed.
Spring pressure returns the pedal to the rest
position when released. Always check that the
throttle pedal returns normally before starting the
engine.
This vehicle is equipped with a throttle release
switch, which is designed to reduce the risk of a
frozen or stuck throttle. If the throttle cable
should stick in an open position when the
operator releases the throttle pedal, engine speed
will be limited, and power to the rear wheels will
be reduced.
Fuel Cap
The fuel tank filler cap is located on the right-hand
side of the vehicle near the passenger seat. When
refueling, always use either leaded or unleaded
gasoline with a minimum pump octane number of
87 R+M/2 octane. Do not use fuel with ethanol
content greater than 10 percent, such as E-85 fuel.
Seat Removal
Pull up on the front of the seat and slide it toward
the front of the vehicle. Install the seat by sliding
the tabs into the rear of the seat base. Push down
firmly on the front of the seat until the pins are
fully seated into the grommets.
Hood Latches
To remove the hood, pull the hood latch lever to
the left and lift the hood away from the vehicle.
Throttle
Pedal
Brake
Pedal
Fuel Cap
Hood Latch Lever
To Next Page
Loading...
Need help?
General
