BRAKES
The front and rear brakes are hydraulic disc type brakes activated by the brake
pedal.
Always check brake pedal travel and the brake fluid reservoir level before each
use of the vehicle. When applied, the brake pedal should feel firm. Any
sponginess would indicate a possible fluid leak or low brake fluid level, which
must be corrected before riding. Proceed to the next page for brake fluid
information.
If you discover any irregularities in brake system operation, including excessive
pedal travel, contact your dealer for proper diagnosis and repairs.
WARNING
Operating the vehicle with a spongy brake pedal can result in loss of braking,
which could cause an accident resulting in severe injury or death. Never
operate the vehicle with a spongy-feeling brake pedal.
BRAKE INSPECTION
WARNING
Do not apply WD-40® or any petroleum product to brake discs. These types of
products are flammable and may also reduce the friction between the brake
pad and caliper.
To inspect the brakes, do the following:
1. Check the brake system for fluid
leaks.
2. Check the brake pedal for excessive
travel or a spongy feel.
3. Check the friction pads for wear,
damage and looseness.
4. Check brake discs for signs of
cracks, excessive corrosion,
warping or other damage. Clean any
grease using an approved brake
cleaner or alcohol.
5. Inspect the brake disc spline and
pad wear surface for excessive
wear. Change pads
q
when worn to
.030” (0.762 mm).
85
MAINTENANCE
To Next Page
Loading...
Need help?
General
