25
FEATURES AND CONTROLS
Seat Belts
This POLARIS vehicle is equipped with three-point lap and diagonal seat belts on all exter-
nal seats.The center seat is equipped with a lap-style seat belt. Always make sure the seat
belts are secured for all riders before operating.
WARNING! Falling from a moving vehicle could result in serious injury or death. Always fasten your
seat belt securely before operating or riding in the RANGER.
To wear the seat belt properly, follow this proce-
dure:
1. For 3-point belts, pull the seat belt latch down-
ward and across your chest toward the buckle
at the inner edge of the seat. The belt should fit
snugly across your hips and diagonally across
your chest. Make sure the belt is not twisted.
For lap style belts, place the belt across your
lap as low on your hips as possible. Make sure
that the belt is not twisted.
2. Push the latch plate into the buckle until it
clicks.
3. Release the strap, it will self-tighten.
Tip: The center belt must be tightened manually by pull-
ing on the strap.
4. To release the seat belt, press the square red
button in the buckle's center.
Seat Belt Inspection
Inspect all seat belts for proper operation before each use of the vehicle.
1. Push the latch plate into the buckle until it clicks. The latch plate must slide smoothly
into the buckle. A click indicates that it's securely latched.
2. Push the red release latch in the middle of the buckle to make sure it releases freely.
3. Pull each seat belt completely out and inspect the full length for any damage, including
cuts, wear, fraying or stiffness. If any damage is found, or if the seat belt does not oper-
ate properly, have the seat belt system checked and/or replaced by an authorized
POLARIS dealer.
4. To clean dirt or debris from the seat belts, sponge the straps with mild soap and water.
Do not use bleach, dye or household detergents.
To Next Page
Loading...
