25
FEATURES AND CONTROLS
Switches
Polaris 3-Mode Throttle Control Switch (if applicable)
The Polaris 3-Mode Throttle Control Switch has three
positions:
• Performance (PERF)
• Standard (STND)
• Work (WORK)
NOTE: Always use low gear for any of the following conditions
regardless of the selected throttle control setting. Refer to
page 22 for more information on gear selection.
• Operating in rough terrain or over obstacles
• Loading the vehicle onto a trailer
• Towing heavy loads
• Driving frequently at low RPM or at ground speeds
below 7 MPH (11 km/h)
Winch Switch
Press the top of the rocker switch to spool line out from
the winch. Press the bottom of the rocker switch to
spool line in to the winch. Move the rocker switch to the
center position to stop spooling.
Remote Winch Switch
Pull the remote winch switch and cable out from the
dash storage area. Press and hold the left side of the
switch to spool line out from the winch. Press and hold
the right side of the switch to spool line in to the winch.
Release the switch and it returns to the center “OFF”
position to stop spooling.
Polaris 3-Mode
Throttle Control Switch
To Next Page
Loading...
