91
MAINTENANCE
Brakes
n Hydraulic Brake Inspection
Inspect the brake lever travel before each use of the snowmobile. See
page 51.
Brake pads must be replaced when the brake pad material becomes thin-
ner than the backing plate, approximately 1/16" (1.5mm). A kit is avail-
able for replacing brake pads. See your dealer.
WARNING
Brake failure during operation can result in serious injury or death. Properly
functioning brakes are vital to your safety. Be sure the brake pads do not
drag on the disc and that brake lever travel is not excessive.
Always replace brake pads when the brake pad material becomes thinner
than the backing plate, approximately 1/16" (1.5mm).
To Next Page
Loading...
Need help?
General
