POLARIS MAINTENANCE SCHEDULE
The intervals shown are based on vehicles operated under normal conditions.
Each interval is given in hours and miles (kilometers). Items should be serviced
at whichever interval comes first following the Initial Break-In Service.
Continue to reference the following maintenance schedules at the given
intervals as hours and miles (kilometers) increase on the vehicle.
Vehicles subjected to severe use must be serviced at 50% of the stated interval.
Examples of Severe Use: Frequent immersion in mud, water, or sand, constant
high RPM use, prolonged low-speed heavy load operation, extended idle, and
short trip cold weather operation.
INITIAL BREAK-IN SERVICE
FIRST 25 HOURS / 1 MONTH
Engine Air Filter
Inspect air filter; replace as necessary. Ensure
proper installation of filter and airbox cover.
Inspect ducts and screens; clean as necessary.
Cooling System
Fluid level inspection; inspect for fluid leaks;
add coolant if needed. Inspect coolant strength
seasonally; pressure test system yearly.
General Lubrication
Locate all applicable fittings and grease.
Shift Cable / Linkage Inspect; adjust as needed.
Battery
Check terminals; terminals should be tight and
free of corrosion. Clean, test, and replace as
necessary.
Engine Oil and Filter Change the engine oil and filter.
Front Gearcase Fluid
Initial fluid level inspection; add lubricant if
needed.
Transmission Fluid
Initial fluid level inspection; inspect for fluid
leaks; add lubricant if needed.
The break-in period consists of the first 25 hours of operation. Careful
treatment of a new engine and drive components will result in more efficient
performance and longer life for these components. The items outlined in this
service interval only need to be performed at the first 25 hours of operation.
They do not need to be performed every 25 hours.
* It is recommended to have an authorized Polaris dealer perform these
services.
78
MAINTENANCE
To Next Page
Loading...
