Polaris SLINGSHOT SL 2019 User Manual

CLOCK MODE
WARNING
The clock must be reset any time the battery has been disconnected or
discharged.
1. Turn the key to the ON position. Use the MODE button to toggle to the
odometer display.
2. Press and hold the MODE button until the hour segment flashes. Release
the button.
3. With the segment flashing, tap the MODE button to advance to the desired
setting.
4. Press and hold the MODE button until the next segment flashes. Release the
button.
5. Repeat steps 3–4 twice to set the 10-minute and 1-minute segments. After
completing the 1-minute segment, step 4 will save the new settings and exit
the clock mode.
6. Turn the key to the OFF position.
ODOMETER/TRIP METER MODE
The odometer displays the total distance traveled by the vehicle. Each trip
odometer displays distance traveled since the trip odometer was reset. To view
the trip odometer, turn the key to the ON position. Use the mode button to toggle
to the trip odometer.
To reset the trip odometer, toggle to the trip odometer, then press and hold the
mode button until the trip odometer resets.
ENGINE ERROR CODES
The error screen displays only when the CHECK ENGINE light is on or when it
goes on and off during one ignition cycle. Error codes are not stored. When the
key is turned OFF, the code and message is lost, but will reappear if the fault
reoccurs after restarting the engine.
If the CHECK ENGINE indicator lamp illuminates, retrieve the error codes from
the display.
1. If the error codes are not displayed, use the MODE button to toggle until “Ck
ENG” displays on the main line of the display.
2. Press and hold the MODE button to enter the diagnostics code menu.
3. Record the numbers displayed in the gear position (if any), clock and
odometer displays.
4. Press the MODE button to advance to the next error code.
29
FEATURES AND CONTROLS
Downloaded from ManualsNet.com search engine

Polaris SLINGSHOT SL 2019 Specifications

General

Brand	Polaris
Model	SLINGSHOT SL 2019
Category	Automobile
Language	English