CHANGING THE PASSCODE
The factory-set passcode is 0000. Enter this passcode at step 5 the first time
you change the passcode.
1. Unlock the security system. See page 46.
2. With the engine off and the park brake engaged, press and release the
MODE button repeatedly until “SECURE” displays in the gauge.
3. Press and hold the MODE button until “SETCODE” displays.
4. Press and hold the MODE button until “OldCodE” displays.
5. Enter your existing passcode using the same process used to unlock the
system.
6. If the passcode is not correct, “bAd COdE” displays. Re-enter the correct
passcode. If the passcode entered is correct, “NEWCodE” displays.
7. Enter your new passcode using the same process used to unlock the
system.
8. When “CONFIRM” displays, re-enter the new passcode to confirm.
9. If the two entries do not match, “bAd COdE” displays and you’ll be returned
to step 7. If the two entries match, “SUCCESS” displays. The passcode has
been changed.
10. Record your new passcode and keep it in a safe location. Do not place your
4-digit passcode anywhere in the vehicle.
SECURITY LEVELS
The security system offers three security levels as outlined below:
SECURITY
LEVEL
ENGINE STARTING REQUIREMENTS
PASSIVE
(default
setting)
When set to PASSIVE, use of the ignition key is required. Manual entry of
your passcode is not required.
ACTIVE When set to ACTIVE, you will be prompted to press the MODE button
within 10 seconds of turning the ignition switch off. The system will then
require manual entry of your passcode the next time the ignition switch is
turned on. See Unlocking the Security System. If you fail to press the
MODE button within the allotted time, the system will not require manual
entry of your passcode the next time the ignition switch is turned on.
AUTO When set to AUTO, the system requires manual entry of your passcode
every time the ignition switch is turned on.
45
FEATURES AND CONTROLS
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
Need help?
General
