• Accelerating, page 59
• Braking, page 59
2. Perform the Pre-Ride Inspections. See page 47.
3. Insert the key into the ignition switch. Turn the key to the ON position. You
should hear the fuel pump run momentarily as it pressurizes the fuel system.
4. Release the park brake.
5. Depress the clutch pedal fully to disengage the clutch.
6. Press and release the one-touch starter switch
q
to start the engine.
7. If either the check engine indicator or the low oil pressure indicator
illuminates after the engine starts, stop the engine immediately. Refer to
either the check engine indicator information or the low oil pressure indicator
information found on page 25.
8. With the brake applied, allow the engine to idle. Idle speed will gradually slow
to normal as the engine warms to operating temperature.
SHIFTING GEARS
WARNING
Forced shifting (without depressing the clutch pedal) could cause damage to
the engine, transmission and drive train. Such damage could cause loss of
control, which could result in serious injury or death. Always depress the clutch
pedal fully to disengage the clutch before shifting gears.
56
OPERATION
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
Need help?
General
