1. Insert the fuel nozzle into the fuel tank filler neck. Do not leave the nozzle
unattended while fueling.
2. Fill the fuel tank until the pump stops. Do not overfill.
WARNING
Fuel expands in the fuel tank. To prevent leaks, make sure the fuel filler cap is
properly seated. Do not overfill.
NOTICE
Fuel can damage painted surfaces and plastic parts. If gasoline spills on the
any part of the vehicle, immediately rinse it off with water or wipe it dry with a
clean cloth.
PRIMING THE FUEL SYSTEM
If the vehicle runs out of fuel, prime the fuel system before attempting to restart
the engine.
1. Fill the fuel tank.
2. Turn the ignition key to the ON position.
3. Allow the fuel pump to run until it stops (about 5 seconds).
4. Turn the key to the OFF position and wait 10 seconds.
5. Repeat steps 2 – 4 three more times, then start the engine. See page 55.
STARTING THE ENGINE
The starter interlock system allows the engine to be started only when the clutch
is disengaged (clutch pedal fully depressed).
NOTE
If the vehicle runs out of fuel, prime the system before attempting to restart the
engine. See page 55.
1. If this is your first time operating the SLINGSHOT, read and understand the
following sections of this manual before starting the engine:
• Safety, page 10
• Safe Driving Practices, page 12
• Shifting Gears, page 56
55
OPERATION
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
Need help?
General
