6. Rinse the plug wells with water and dry with compressed air.
NOTE
Spark plug wells have drain holes built into the cylinder head to allow water to
drain out.
7. Remove the spark plugs. Tool: 5/8” spark plug socket with extension.
8. Inspect electrodes for wear and carbon buildup. A good plug will have a
sharp outer edge with no rounding or erosion of the electrodes.
9. Do not attempt to adjust spark plug gap.
10. Reinstall the spark plugs or install new plugs.
11. Tighten spark plugs to specification.
12. Reinstall the ignition coils.
13. Reinstall the ignition coil bolts. Tighten to specification.
TORQUE
7.5 ft-lbs (10 Nm)
14. Connect the spark plug wires to the ignition coils.
ENGINE COMPRESSION TEST
An engine compression test can be performed to monitor general engine
condition. Refer to the SLINGSHOT Service Manual, or your authorized dealer
can assist.
EXHAUST SYSTEM INSPECTION
Check the exhaust system for stains from leaking exhaust gasses. Replace
damaged or leaking exhaust gaskets. Tighten loose clamps and fasteners. Refer
to the SLINGSHOT Service Manual, or your authorized dealer can assist.
BATTERY
WARNING
Improperly connecting or disconnecting battery cables can result in an
explosion and cause serious injury or death. When removing the battery,
always disconnect the negative (black) cable first. When reinstalling the
battery, always connect the negative (black) cable last.
96
MAINTENANCE
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
Need help?
General
