CLUTCH
6.24
EBS DRIVEN CLUTCH
REASSEMBL
Y
1. Press the bearing onto the output shaft using a
press.
2. Install the shaft/bearing into the outer sheave.
3. Install the small and large retaining rings into the
outer sheave above the bearing.
4. Line up the “X” ont the moveable sheave with the
“X” on the stationary sheave or use the marks
previously used. Put the sheaves together.
Align X’s
5. Install the roller (A) onto the roller pin (B). (Both
Sides)
A
B
To Next Page
Loading...
