3
3.63
9924864 - 2012-2014 SPORTSMAN 800 / 6X6
© Copyright 2013 Polaris Sales Inc.
36. Secure the gear/stator housing cover (O) to the
crankcase with the cover bolts. Torque bolts in
proper sequence to specification. Remove seal
protectors from the shaft ends once secure.
Gear/Stator Housing Bolt:
96 ± 3 in-lbs (10.85 ± 0.35 Nm)
*Torque in proper sequence
NOTE: Before assembly, clean the bolts and bolt
holes with Primer N (PN 2870585) to remove any
debris. This will ensure proper sealing when
installing bolts.
37. Install shaft seal with ceramic surface facing inward.
38. Install water pump impeller (P). Secure the impeller
with the washer and a new nylok nut (Q). Torque
the nut to specification.
Water Pump Impeller Nut:
108 in-lbs (6.8 Nm)
ENGINE
To Next Page
Loading...
