Polaris Virage TX 2000 Service Manual

ENGINE
Assembly - Polaris Engines
63 .If impulse fitting was removed, apply pipe sealant
and reinstall. Torque to specification. If crankcase
drain plugs were removed, re-install with new sealing
washers and torque to specifications.
Crankcase Drain Piug Tor^tif^^ :; ; :
64 . Lubricate and install a new O-ring on oil pump. Line
up drive spade on pump with slot in flywheel nut and
install. Apply Loctite™ 242 (blue) to the bolts and
torque evenly to specifications.
Oil Pump Bolt Torque*
60 in. lbs. (6.9 Nm)
65 . Install oil pump cable and connect oil lines to oil pump
and carburetors (throttle bodies). Adjust as outlined
on pages 2.18-2.22.
66 .Bleed oil pump and oil lines to ensure no air is
trapped in pump or lines - see page 4.41.
67 .Apply a light film of grease to crankshaft threads and
install drive coupler. Tighten hand tight.
68 .Thoroughly grease splines inside coupler and
replace sealing O-ring.
69 .Install ignition coils. Torque to specification.
Ignition Coil Bolt Torque-
108in. lbs. (12.4 Nm)
3/00
4.40
Polaris Sales Inc.

Polaris Virage TX 2000 Specifications

General

Brand	Polaris
Model	Virage TX 2000
Category	Boat
Language	English