Polaris Virage TX 2000 Service Manual

MAINTENANCE/TUNE UP
Engine
Oil Filter
The oil filter is located in-line between the oil tank and the oil pump on all models. The in-line oil filter is a special
type and must not be substituted. Replace the oil filter annually or whenever water or debris has entered the oil
tank. Do not attempt to clean this filter.
1. Cut cable tie straps, or remove clamps, securing
lines to filter.
2. Remove lines and replace filter with arrow pointing
in direction of oil flow (towards pump).
3. Install new cable tie straps, or reinstall clamps, on
each line and check for leaks.
Oil Pump Adjustment
NOTE: Adjust idle speed and throttle lever freeplay be
fore performing oil pump adjustment.
1. Inspect mark on oil pump lever and index mark on oil
pump body. The marks should align with throttle
released (idle speed). The lever should move
immediately when the throttle is opened slightly.
2. If marks are not aligned, loosen cable adjuster nuts
and adjust until marks are aligned.
3. Tighten nuts securely and recheck adjustment.
3100
2.18
Polaris Sales Inc.

Polaris Virage TX 2000 Specifications

General

Brand	Polaris
Model	Virage TX 2000
Category	Boat
Language	English