10
Remote Control
1. POWER Turns the LED TV on and off (standby mode).
2. MTS In NTSC receiving mode, press to select.
the audio modes to Mono, Stereo or SAP.
In ATSC Digital receiving mode, press to display
theaudio selection menu on the screen. Using the
Navigator▲,▼button to select the desire audio
mode.
3. S.MODE Sound Mode, press repeatedly to select
the presetting sound effect modes.
4. P.MODE Picture Mode, press repeatedly to select
the preset picture modes.
5. SLEEP Press repeatedly to activate and/or set the
sleep timer.
6. ASPECT Press repeatedly to select the aspect
ratio of screen as desired.
7. 0-9 Numeric buttons.
8. —.Select channel with two digits.
9. RECALL Recall Mode.
10. VOL+/VOL- Press to increase or decrease the
volume level.
11. CH+/CH- Press to increase or decrease the
channel number.
12. Turn off the sound temporary. Press again to
turn the sound back.
13. Play/Pause picture.
14. DISPLAY Press to display the information;
settings and the status of current mode/station
on the screen.
15. SOURCE Press to display the source menu on
the screen. Using the Navigator ▲ or ▼ buttons to
select the source as desire then press (ENTER) button
to confirm your selection.
16. ▲▼ ►◄/ ENTER Press to move the cursor within
the setting menu. ENTER Press the ENTER button to
confirm the selection. Press the "ENTER" button, the
check mark will appear to the channel , and the channel
is marked as channel list.
17. MENU Displays the setting menu on the screen.
18. EXIT Press to exit from the setting menu.
19. Chromecast built-in Enter cast connect surface
20. EPG Press to display the Electronic Program Guide in digital
TV channels(Operation in ATSC mode only functions on signals emitting from TV station) .
21. ADD In FAV display mode, press to increase or delete the highlighted channel.
123
456
789
0
SOURCE
TIXEUNEM
CH
.VAFCC
P.MODE S.MODE SLEEP ASPECT
MTS
RECALL
EPG
-VAF+VAF
ADD
6
4
3
1
7
8
10
13
14
16
17
19
20
23
22
5
9
11
15
18
21
24
25
12
2
To Next Page
Loading...
Need help?
General
