42
Setting the Date Stamp
The date of recording can be printed directly on the still
images. This function must be activated before the image is
captured. Once date and time are stamped on an image, they
can no longer be edited or deleted.
Limitations of Date Stamp functions are as follows:
• Available for still images only.
• May slow down AEB/ Burst mode when Date Stamp is
enabled in AEB/ Burst mode.
• In vertical or rotated images, the date and time on your
images still appear horizontally.
To set Date Stamp
1. From the Record menu, select Date Stamp.
2. Use the or keys to go through the selection.
3. Press the OK button to save and apply changes.
Setting Auto Review
The Auto Review function lets you view the captured image
right after shooting it.
If Auto review is On, the camera will display the captured
image for 1 second on the LCD monitor.
To set Auto Review
1. From the Record menu, select Auto Review.
2. Use the
or keys to go through the selection.
3. Press the OK button to save and apply changes.
Setting Stabilizer
This function allows you to prevent blurred images caused by
shaking.
1. Enable the Stabilizer under the Record Menu.
2. Use the
or keys to go through the selection.
3. Press the OK button to save and apply changes.
To Next Page
Loading...
Need help?
General
