Note: To properly use the Face Detect option, please ensure the following:
MACRO Mode OFF – Face Detect will not work if the camera is in Macro mode.
Anti-Shake – Ensure that the Anti-Shake option is set to ‘On’. The Anti-Shake option is ‘On’
by default when you start using your camera and assists you in properly focusing the image.
Distance from the camera – The subject’s face must be no further than 8 to 9 feet (3.5
meters) from the camera and the face must cover at least 20% (1/5
th
) of the picture as seen
on the LCD screen.
Facing the camera – Face Detect will not work with a side shot of the subject’s head. The
face of the subject(s) you are photographing must be facing the camera and must hold the
pose for at least 4 to 5 seconds until the green square(s) appears around the subject’s face.
1) Press the SET button to open the menus for the current mode.
2) Press the LEFT or RIGHT button to scroll and select the ‘Face Detect’ menu.
3) Press the UP or DOWN button to highlight a specific option.
4) Press the SET button to confirm and select the highlighted menu option.
A selected option icon appears on the selected item.
5) To continue within the menus and select a different menu option:
Press the LEFT or RIGHT button to select the next menu item.
6) To exit the menu view:
Press the MODE button to exit the menu and return to your previous mode.
An icon reflecting your selection is displayed on the LCD screen.
With the ‘Macro’ feature you can capture images at close range (30 ~ 45 cm).
MACRO ON: To enable the Macro mode, select ‘On’.
The flower icon appears on the LCD display and indicates that the Macro mode is ON.
When enabled, the Macro mode will allow your camera to focus on an object that is close to
the camera.
MACRO OFF: To disable the Macro mode select ‘Off’.
The mountain icon appears on the LCD display.
When Macro mode is off, images can be captured from 1.5m - ∞ (infinity).
To Next Page
Loading...
