Battery Power:
Some features, will not work if the battery power level is low.
When the battery power is low the battery icon turns red and the camera will
automatically turn off a few seconds later.
The energy status of the power is displayed on LCD as shown below:
Full battery power Medium battery power Low battery power
2) SD Card
Make sure an SD card has been properly inserted into your camera. (SD card not included.)
To properly insert the SD Card:
Push the SD card into the slot in the direction shown on the camera (see SD icon by the
SD card slot).
Push the SD card until you hear a slight clicking sound. This indicates the SD card has
been inserted correctly.
Note:
After the camera is powered on, an SD icon will appear on the LCD display. If you do not
see the SD icon on the display, please check if the card was inserted properly.
Make sure the SD card is not locked (check the lock switch on the side of the SD card).
If the SD card is locked this will prevent the camera from saving captured photos to the
SD card.
3) Power On
Press the POWER button to turn on the camera.
After powering on your camera for the first time, you will be prompted to select a language for the
camera. The Language selection menu appears. Select the language of your choice by pressing
the UP and DOWN direction control buttons. Then press the SET button to confirm the selection.
To Next Page
Loading...
Need help?
General
