14
EXPLANATION:
1 If the camera is not turned on, the shutter, rangefinder and flash
won’t function. Push the switch to “1” to turn on the power.
2 If the flash head is not raised all the way, the flash will not turn
on.
3 If the camera is turned on with the flash in the upright position
the green ready light should be lit, if not, check the 6 volt battery.
The best method for doing this is to disconnect the 6 volt battery
and try operating the camera with four 1.5 volt AA batteries
installed in the hand grip. Make sure the batteries are properly
orientated. If the flash fires, the 6 volt battery was at fault and
should be replaced.
4 If the problem persists, the camera is probably defective and
should be returned for repair.
To Next Page
Loading...
