16
Attachment:
1. Cleaning parameter adjustment:
1) Left and right position of ink stack: after online, the ink stack cap should be in the center position
of the head. If there is a deviation between the left and right, you can initialize the interface in
the software factory mode and adjust the zero return distance parameter after hitting the limit
position. After modification, click the Save option under the file in the upper left corner to make
the parameter effective. After saving, click the initialization in the upper left corner to observe
whether the left and right alignment of the printing head and ink stack is centered.
2) Ink stack height adjustment: observe whether the moisture retention and ink pumping height of
the ink stack fit the head. If the ink pumping height is not enough, adjust the ink pumping height
by increasing 300 pulses each time to ensure that all the nozzles can absorb ink smoothly. The
scraping height should be about 1mm higher than the surface of the head.
matters needing attention:
• The ink pad should not be too high to prevent the nozzle from being damaged.
• During printing, the ink pad shall be attached to the head, and shall not be too high or too
low to prevent ink accumulation on the surface of the nozzle during flash spraying, which
may cause color mixing and wire breakage.
To Next Page
Loading...
