GP44 Semi-Automatic Strapping Machine
OPERATION -15-
When the machine stops due to some trouble, press this switch so that the machine goes back to
the home position.
Strap is cut and remains in the arch and it must be removed by hand.
NOTE: Turn strap feed switch (located on the side of the machine) OFF then back ON to feed strap
around arch.
5. Circuit Power Switch (with light)
Power light glows when all safety switches are clear and Circuit Power Switch is pressed
The machine can be ready for using after 30seconds (after heater blade warms up).
6. Emergency Stop Switch
When it is pressed, all operation of the machine and all pilot lights are turned “OFF”.
NOTE: Power still remains in the machine when Emergency Stop Switch is pressed.
Make sure to disconnect power cable when you inspect the inside of the machine.
To Next Page
Loading...