4
5. Connect and hand tighten a 5/8” garden hose to the vacuum head.
NOTE: If your garden hose is designed with quick-connect couplers, add an attachment adapter to the
end of the garden hose before connecting to the vacuum head.
10. When done or when the bag is full:
a. Slowly move the vacuum head to the side wall of the pool, turn the vacuum head up-side-down,
shut off the water and remove the vacuum head from the pool.
b. Remove the vacuum bag and discard all the debris, flip the bag in-side-out and rinse with running
water.
11. Repeat the vacuuming process until the pool is thoroughly cleaned.
6. Secure the hose into the hose clip. 7. Place the vacuum under water.
8.
Turn on the water supply, this will create
a venturi action at the vacuum head
to collect debris into the vacuum bag.
9. Slowly push the vacuum head across the pool
floor to remove debris.
Hose Clip
5/8” hose
Vacuuming with a 5/8” NPT Thread Garden Hose (not included)
1.
Extend the telescopic pole to its fullest
length.
2. Attach the vacuum head to the open end of
the telescopic pole.
3. Attach the vacuum bag to the vacuum
head, tighten the drawing string and tie
a simple shoelace knot.
4. Twist off the water hose cap.
EN
5/8” Garden Hose
Attachment
Adapter
5/8”
Garden Hose
Quick-Connect
Coupler
or
To Next Page
Loading...
