Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
MST. Extended operating days and hours during peak season requirements.
OWNER′S MANUAL
3
5. Hand tighten a 5/8” garden hose to the vacuum head.
6. Slip the hose into the hose clip. 7. Place the vacuum under water.
10. When done or the bag is full:
(1) Slowly move the vacuum head to the side wall of the pool, turn the vacuum head up-side-down, shut off the water and lift the vacuum head out of the pool.
(2) Remove the vacuum bag and discard all the debris, flip the bag in-side-out and rinse with running water.
11. Repeat the vacuuming process until the pool is thoroughly cleaned.
8. Turn on the water supply, it will create a venturi action at
the vacuum head to collect the debris inside the vacuum bag.
9. Slowly push the vacuum head across the pool floor to remove the debris.
Hose Clip
5/8” hose
To Next Page
Loading...
