To Next PageTo Next Page
Need help?Do you have a question about the PONGPENG SF5040 and is the answer not in the manual?
General| Model | SF5040 |
|---|---|
| Category | Power Tool |
| Type | Angle Grinder |
| Power | 850W |
| No-Load Speed | 11000 RPM |
| Disc Diameter | 100mm |
| Spindle Thread | M10 |
Ensure children are kept away from the work area and do not handle the tool.
Wear safety glasses and ear protection to prevent injury from fasteners and noise.
Never use oxygen, combustible, or other bottle gas as power source to avoid explosion.
Do not connect tool to compressed air exceeding 120psi.
Avoid long air hoses in work area to prevent tripping hazards.
Carry tool by handle and avoid keeping trigger pulled to prevent unintentional firing.
Point tool away from yourself and others, keep body parts clear of rear area.
Disconnect tool from air supply before loading fasteners to prevent accidental firing.
Do not keep trigger or safety depressed during loading to prevent accidental firing.
Details of the 2-in-1 nailer/stapler, its features, and applications.
Instructions and requirements for connecting compressed air to the tool.
Steps for inserting fasteners into the magazine and preparing the tool.
Procedure for driving fasteners using the safety stand and trigger.
Guidance on lubricating the tool with pneumatic oil for optimal performance.
Checking and replacing worn parts, and inspecting safety mechanisms.
Common causes and solutions for air leaks from the tool.
Troubleshooting for slow driving, skipping fasteners, or jamming.
A detailed list of all parts for Model SF5040 with their corresponding numbers.
