How to improve suction capacity of Pontec PondoMatic?
To improve the suction capacity of your Pontec Vacuum Cleaner, ensure you hold the suction tube as flat as possible and remove the non-return valve from the nozzle. The more tubes used, the higher the tube frictional resistance, which reduces suction capacity.
What to do if Pontec PondoMatic Vacuum Cleaner does not reach full capacity?
If your Pontec Vacuum Cleaner isn't reaching its full capacity, it may be due to accumulated dirt. Make sure to remove any dirt from the foam filter, suction tube, or suction hose. Also, check the non-return valve area on the drain hose for dirt that may prevent proper closure.
Why Pontec PondoMatic does not perform its suction function?
If your Pontec Vacuum Cleaner isn't performing its suction function, check the drain hose fitting. The non-return valve must be located at the free end of the drain hose. Also, consider the height difference between the water level and the unit; placing the unit at the same height as the water level is recommended.
General| Brand | Pontec |
|---|---|
| Model | PondoMatic |
| Category | Vacuum Cleaner |
| Language | English |
Safety precautions and requirements for electrical installation.
Rules for safe use, minimum distances, and cable handling.
Approved uses and substances not to be collected by the unit.
Details of the unit, included parts, and primary function.
Step-by-step guide for unit setup and hose connections.
Instructions for vacuuming sludge from ponds and pools.
Steps for cleaning, wear parts, and troubleshooting malfunctions.
Instructions for storing the unit and proper waste disposal.
Details of the product guarantee and terms.
To Next Page
