2-7
Power Door Locks
Press the power door lock
switch located on the
driver’s door to lock or
unlock both doors at once.
The power door lock switch works at all times, except
when lockout prevention (if equipped) is programmed.
The unlock switch only works when the ignition is in
RUN, ACCESSORY or when Retained Accessory
Power (RAP) is active. See “Retained Accessory
Power (RAP)” in the Index.
Operating the power door locks may affect the
content theft
-deterrent/alarm system (if equipped).
See “Content Theft
-Deterrent/Alarm System” in
the Index.
Last Door Closed Locking
You can program your vehicle to delay the locking of
the doors. This lets you and your passengers exit the
vehicle after you’ve pressed the power door lock switch.
All of the doors will lock once everyone has gotten out
of the vehicle and the doors are closed.
When the power door lock switch is pressed, a chime
will sound three times, indicating that the last door
closed locking feature has been activated. Pressing the
power door lock switch again will lock the doors
immediately. Pressing the unlock switch will cancel
a previously requested last door closed locking.
The vehicle is shipped from the factory with this
feature turned off. To turn this feature on,
see “Feature Customization” in the Index.
To Next Page
Loading...
Need help?
General
