Getting to Know Your 2004 Aztek
16
Setting Up the Tent (optional)
• Open the hatch and lower the tailgate
• Unroll the tent and slip it over the
hatch with the Aztek logo facing
outward
• Install the hatch strut supports to
keep the hatch from inadvertently
closing. Place one support on each
side, starting from the bottom and
working your way up
• Once the tent is supported by the
hatch, cover the bumper with the
fabric at the bottom of the tent
Note: Before getting started, make
sure your Aztek’s engine and exhaust
has cooled to prevent injury and dam-
age to the tent.
• Locate the two attaching straps at the
leading edge of the tent. Secure
them to the roof rail tie-down ring on
top of the vehicle
• Locate the two attachment points on
the passenger side wheelwell. One is
a hole in the wheelwell, the other is
the edge of the frame. Using these
points, clip on the attached hooks
(repeat procedure on driver’s side)
• Locate and assemble the fiberglass
tent pole to its full length. Ensure
each of the nine segments are firmly
seated at their connection points
• Feed the pole through the nylon
sleeve located above the tent’s zipper
door
To Next Page
Loading...
