EasyManua.ls Logo

Pontiac Wave 2008 - Headlamp Aiming

Pontiac Wave 2008
380 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
To disconnect the jumper cables from both vehicles,
do the following:
1. Disconnect the black negative () cable from the
vehicle that had the dead battery.
2. Disconnect the black negative () cable from the
vehicle with the good battery.
3. Disconnect the red positive (+) cable from the
vehicle with the good battery.
4. Disconnect the red positive (+) cable from the other
vehicle.
5. Return the positive (+) terminal cap to its original
position.
Headlamp Aiming
Headlamp aim has been preset at the factory and
should need no further adjustment.
However, if your vehicle is damaged in a crash,
the headlamp aim may be affected. Aim adjustment
to the low-beam headlamps may be necessary if
oncoming drivers flash their high-beam headlamps at
you (for vertical aim).
If the headlamps need to be re-aimed, it is
recommended that you take the vehicle to your
dealer/retailer for service.
5-43

Table of Contents

Related product manuals