®
2
Installation Guide - NiMH to Lithium
Need Help? Contact Customer Care at (732) 967-9888
Upgrading the Pool Blaster® iVac M3 Motor Box
STEP 3: Remove the 4 screws on the main
body.
STEP 4: Using a screwdriver, remove the
small screw as shown above.
STEP 5: Separate the shells until you have
access to the motor box. Remove the old
motor box and discard it as per your town’s
recycling regulations.
STEP 6: Make sure to grab the shell where
the old motor box was and face it down as
shown in the image above.
To Next Page
