Pool Warehouse SUNRAY - Page 43

No Diving or Jumping. Observe all Safety Rules.
3-7
2. Fasten the Liner in place (Overlap Liner only)
a. Starting at the liner wall seam,
hang the liner over the wall mak-
ing sure that the seam is straight
up and down, perpendicular to the
oor.(Removestabilizersgradually
as you fold the liner over the top of
the wall. )This will assure you that
the liner begins going over the wall
straight.
b. As you put the liner over the wall
you can secure it by using the plas-
tic coping strips to keep it in place.
If you end up with excess material,
continue around the pool, pulling ex-
cess liner evenly, and distribute over
the wall until the excess is gone.
c. Fasten the liner to the top of the wall
with plastic coping. Let the liner
hang slack for now. Do not pull the
liner tight.
NOTE:Somelinersmaytverytightly,
it is better to install uprights, top
plate and top ledge before going
onto next step. See Section 4.
d. Turn the vacuum cleaner on and
push the liner outward with your
feet to iron out any wrinkles. Once
nished,turnoffvacuumcleaner.
e. Startllingthepoolwithwater.As
thepoollls,workoutallthewrin-
kles and smooth the liner to the wall.
Remove the plastic coping around
the top edge of the wall one piece
at a time and adjust the liner. Keep
smoothing out the wrinkles.
f. After all the wrinkles in the liner are
removed, trim any extra length of
plastic coping so there is no overlap.
g. Roll up any excess liner hanging
below the plastic coping and tape it
in place near the top of the pool wall.
Important: Do not trim off the excess
liner.
Plastic Coping
Outside Pool Wall
Liner Overlap
18
19
Important:
Do not trim off the excess
liner. (If the liner ever
needs to be removed,
trimming the liner will
make re-installation very
difcult.)Instead,rollup
any excess liner and tape it
in place near the top of the
pool wall.
20
21
Important: This
step applies only if
you have an Over-
lap Liner. See next
page for Beaded
Liner or V-Bead
Liner.