Pool Warehouse SUNRAY - Fill Pool with Water

No Diving or Jumping. Observe all Safety Rules.
4-3
 B. FillyourPoolwithWater
1. Finishllingthepool
a. Turnoffthevacuumandcarefullyremoveitfromthepool.
b. Fillthepoolwithwaterto2”(5cm)belowthelowestopen-
ing.Makesureyouremoveanycreasesfromthelinerin
thebottomofthepoolbeforethewaterlevelgetstoohigh.
c. Whilethepoolislling,removethenailsthatwereholding
thebottomrailsinplace.
d. Yourpoolisnowinstalled.Youmustnowinstallthelter
andpump,theskimmerandwaterreturninlet.Pleasefollow
theinstallationinstructionsthatcomewiththeseproducts.
Caution:
Before making any
openings in the
liner, fill the pool
with 60cm (24”) of
water to stretch the
liner fully. When filling
your pool, begin with
a garden hose until
there is about 30cm
(12”) of water in the
pool. This will allow
the liner to stretch
gradually. You can
then use a heavier
flow to finish filling
it up.
Important:
Make sure that your pool is round, do not assume that by filling up the pool that this will help
the pool to place itself into a perfect round circle. Ensure that it is round before filling up the
pool with water.
IMPORTANT SAFETY INFORMATION:
Please refer to the safety page at the beginning of this instruction manual. You must follow the
rules and information regarding placement of safety stickers on your pool.