ASSEMBLY and OPERATION of your JET RUNNER MOTORIZED RIDE-ON
Once the batteries have been installed,
add the shaft slips to the Jet Runner unit
– one through the (A) bottom and the other
through the top (B).
4.
When the shaft slips are inside, first add the motor from the bottom and
then add the steering unit from the top until they clip into each other.
A
4.
5.
B
5.
To Disassemble: Locate the two blue buttons on the underside of the
Steering Unit. Press both buttons at the same time to release the
Steering Unit from the Propeller Assembly.
4.
To Next Page
Loading...