(5) Thread each motor through the hole in
each arm rest on the inflatable.
(6) Once each motor shaft
is inside the inflatable,
place the battery
compartment in the battery
compartment tray and clip
the motor shaft back
underneath the battery
compartment tray. Then
push the entire assembly
down into the armrest hole.
(7) Install the 8 x D
batteries into the battery
compartment following the
polarity indicated.
(8) Then place the handle
cover back on and screw
the plastic nut back on top.
You are then good to go!
5
6
ASSEMBLY and OPERATION of your TUBE RUNNER PRO
5.
8
7
To Next Page