Pooli Climber Pro - III. Specifications; IV. Operation Instructions; 4.1 Preparing cleaner for use

III. Specifications
1. Rated input voltage: 220VAC (230VAC)/110VAC (120VAC)
2. Frequency: 50Hz/60Hz
3. Output voltage: DC28V
4. Power: Cleaner 112W
5. Cleaning cycle: 1/2/3h
6. Filter capacity: appr. 16m³/h
7. Filter density: 180μm
8. Moving speed: appr. 10.5m/min
9. IP grade: Cleaner IPX8; Power supply: IPX5
10. Max. water depth: 2m
11. Working temperature: 0°C - 40°C
12. Working mode: All / Floor only / Wall only /3 times floor, once wall
13. PH: 7.0 – 7.8
14. IP grade: Cleaner IPX8; Power unit IPX5
IV. Operation instructions
4.1 Preparing the Cleaner for Use
Laying out the cable
Un wind re quired cable to cover the entire pool size, straight the cable along the
pool; side, and make sure there are no twists.;
Placing the power supply unit on proper position; Power supply unit needs to be
placed in a proper position so as to reach the coverage
4
CAUTION:
· Only use the original supplied power supply unit.
· Do not immerse the power supply unit in water.
· Do not plug the power supply unit in before placing the cleaner in the water.;
· Unplug the power supply unit before any serving activity.
· Ensure the power socket is protected by a ground fault interrupter (GFI) earth
leakage interrupter (ELI)