Waterfall Fountain
54507
POOLMAsrtR
\/AVe Make VVater Fun!
770 Del Paso Road, Sacramento, CA 95834-0308
Spray Head (A)
Inlet Connector (D)
Riser (B)
Elbow Connector (C)
Pipe Wrench
Before You Begin: Please note that the SPRAYHEIGHT of the Poolmaster Waterfall Fountain can be adjusted to
your specifications. To do this, some trial and error testing must be done by opening or closing the inlet
connector which is explained in Step 5. Throughout this testing process, the pool pump must be turned off
and on until the desired height is achieved.
Step 1
Attach the Inlet Connector (D) to pool
return until secure. Use the rotating
ring to help securely tighten in place,
ensuring that the connector opening
faces UPas shown. This will allow you
to adjust the spray height easier in
Step 5.
Ring
Connector
Opening
Pool Edge
Pool Wall
Return
Step 2
Attach Elbow Connector (C) to Inlet
Connector (D) - Loosely secure. DO
NOT tighten completely.
Step 3
Attach Spray Head (A) to Riser (B).
Loosely secure. Do NOTtighten
completely.
(D)
(B)
Need Assistance?
Call our Customer Service Line:
800,854.1492
poolmaster.com
inf0@pooImaster.com
O
To Next Page
Need help?
General
