Assembly Instructions
2
Step 1
Thread Net on PVC Hoop.
This is the net right out of the package.
You will be working with the longer looped end.
This is a close-up of the circled portion on diagram 1.
This is one loop.
Fold the loop toward you, creating two loops.
Insert your nger through the two loops.
Release the thumb holding the loop in place and pull
on the two middle strings. The loop should slide up
and catch your ngers.
Take the loop from your nger and slide onto the
basketball hoop. Continue this process with each
loop until all loops are on the hoop.
1
1
2
3
4
5
6
2
3
5
6
4
Step 2
•Attach the Hoop to the Backboard by
inserting (2) 2 ½" Bolts through the Hoop
Bracket, Hoop and Backboard as pictured
and secure with Washers and Hex Nuts.
poolmaster.com
Backboard
Hoop
Bracket
2
½"
Bolts x2
Note: Caution should be taken in the following steps to avoid
drilling holes in liner and/or having drilling debris fall in pool.
This debris may harm the liner if it falls into the pool.
•Attach the 2 PVC Upright Supports (with caps on
the bottom end) to the Backboard using (4) 2'' Bolts
inserted through the front of the Backboard through
the matching holes on the PVC Uprights. Secure with
Hex Nuts.
Step 3
To Next Page
Loading...