EasyManua.ls Logo

PoolRite Surechlor S3500 - Maintenance and Safety; Chemical Balance Guide; Maintenance Frequency; Cell Cleaning Procedure

Default Icon
4 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FOR FURTHER INFORMATION PLEASE REFER TO: www.surechlor.com.au
Chemical Balance Guide
Your S3500 chlorinator is designed to be used for swimming pool water, which needs to be balanced in
accordance with Langlier Saturation Index, with a pH level of 7.2 to 7.6 and maintains the recommended
levels of sanitizer. (i.e 2 - 3 ppm of free chlorine). Regular water analysis and advice on correct addition
of chemicals and/or products to achieve suitable water quality and balance by a reputable professional
pool shop will ensure bather health and comfort and extended equipment service life.
Maintenance Frequency
Initially, check your cell every week for deposits of scale on the electrodes. This will enable you to
determine the cleaning period. Your S3500 cell must be cleaned before scale builds up to the point
where the electrode gaps in the cell are bridged. If the cell operates with scale bridging the electrode
gaps it can be irreparably damaged and the electrodes may have to be replaced. This will aslo void your
warranty.
Cell Cleaning
Manual Procedure
1.
Remove S3500 Power Pack plug from 240 volt power point.
2.
Remove cell from plumbing.
3.
Turn cell upside down (inlets facing upwards) and place on a level non-metallic surface in a well
ventilated area.
4.
Prepare your cell cleaning solution by following the directions supplied by the chemial
manufacturer.
5.
Carefully pour sufficient cleaning solution into the upturned cell so as to fully cover the metal
electrodes.
6.
Allow to stand for 10 minutes then flush out with clean water.
7.
If electrodes still show white deposits, repeat the above steps.
It is recommended that a warm water detergent solution be used to soak the electrodes at this
point if there is any evidence of body fats, oils or grease.
8.
Refit the cell to plumbing line making sure both rubber “O” ring seals are in place.
9.
Re-connect the Power Pack plug to 240 volt power point and switch on.
General Warnings
The Warranty will be void if the Power Pack is installed or operated:
On, or less than 1 metre from the ground.
Placedinalocationthatcanbefloodedbystormwaterorbyaccidentalimmersion.
Wheretheairflowisobstructed,i.e.Withinapoorlyventilatedauxiliaryenclosure.
Mountedcloseto,against,orontopofanauxillaryheatsource(e.gmetalfenceorshedwall)
WiththeweatherproofControlPanelCoverpermanentlyopenorremovedifinstalledoutdoors
Withapumpconnectedtothe240voltoutletsocketgreaterthan1.5Kwcontinuouscapacity
Fromanelectricalsupplysocketwhichisnotratedtosupply10ampsat220–240volts50Hzandisnot
adequately protected by the correct size fuse or circuit breakers.
Extensionleadsarenotrecommendedforusewiththisequipmentbecausetheyareunsafeinand
around the pool zone.
For extended equipment service life and peace of mind, Poolrite Chlorinator Systems Pty Ltd recommends that
your S3500 is serviced regularly on a six monthly basis by a reputable qualified pool professional.
operationoperationinstallationinstallation maintenancemaintenance
PLEASE NOTE:
Proof (i.e. hard copy) of regular water
analysis by a reputable professional
pool shop will be required as evidence
of suitable water quality and balance in
the event of a warranty claim.
HANDLING ACID:
Rubber gloves and protective
eyewear must be worn.
DO NOT put used acid solution
into the pool
If this system is fitted with a
backup battery and real time clock.
The time will not require resetting.
Under no circumstances should salt,
algaecides, chemicals and any other
product other than DE be added to the
pool via the skimmer box while in
operation
3
5

Related product manuals