2
CAUTION
During the hottest days of summer, it is possible that the temperature of the water
contained in the tank exceeds 60°C. Before taking a shower, mix the water, put the mixer
on «cold water» and then adjust the temperature progressively until obtaining a pleasant
temperature.
Do not touch the surface of the shower in order to avoid any risk of superficial burns.
It is possible that water continues to run after turning off the shower. This is normal and it
stops within the following 10 – 15 seconds.
Do not use the shower in case of storms, in order to avoid any risks of lightning.
The solar shower is designed to be used under “normal” water supply conditions, with a
pressure lower than 3 bars (3 kg). Otherwise provide a pressure reducer.
INSTALLATION
1. Choose a location well exposed to direct sun-
light (ideally to 360°) near a water supply and
drainage.
2. Install the shower head fastening it on the
shower body.
3. On a solid support (cement, reinforced
concrete, heavy wooden base) drill 4 holes
approximately of 12mm of diameter and of 70
mm of depth, using the base of the shower as
a reference.
4. Put the anchors and install the solar shower
vertically with the help of washers and screws.
5. Assemble the pressure reducer and the
threaded tap connector then fastened it on
water inlet. Connect to the water supply. If
necessary use an adapter.
This solar shower is intended for external use, near a swimming pool, on a beach
or in a garden. Before using your new solar shower, please read the recommenda-
tions and the user’s manual.
INSTALLATION GUIDE AND USER’S MANUAL
Solar shower
INSTALLATION GUIDE AND USER’S MANUAL
To Next Page
Loading...
