EasyManuals Logo

POPCORN HOUR A-210 Installation Guide

POPCORN HOUR A-210
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
A-210 Upgrade Kit Hard Disk Installation Guide
25.5 cm (H)
38 cm (W)
Steps Installation
Installation Guide for Popcorn Hour A-210 aluminum case
Step 4
Remove the PCB from A-200 case.
1. Unscrew 3 screws holding the PCBA to
the case.
2. Lift up the PCBA but be careful of the
connector connecting the extension board.
Step 1
Fl ip the A-200 over to sho w it’s u nder side .
Remove the 2 screws located at the front of the
device near the ru bber pads, th en rem ove the 3
screws located at the back of the devive at the
protruding ledge.
Step 2
Tur n t he A-20 0 s o t hat th e top logo i s f acin g you.
Gra sp the lid at the back of the d evic e and gen tly
li f t i t towards you. The l id will c ome fre e w ith a
loud click. Set the lid aside.
Step 3
Inside the A-200, remove the screw on the right
of th e plas tic HDD tr ay. Gently sid e the tray to
the right to remove it.
Step 5
Remove fan from PCBA.
1. Disconnect the fan power pin.
2. Flip the PCBA and locate 2 pin as shown, use
a plier to squeeze the pin out carefully.
3. The fan should pop out now, you may place
the fan aside.
Step 6
Preparing the A-210 upgrade kit.
1. Remove 3 screws from both sides of the A-210
case a s show n. DO NOT r emove the 4th sc r ew,
crossed out in the diagram.
2. Remove 1 screw from the back panel.
3. Flip the case and remove 2 screws from side.
Step 7
Remove the top cover of A-210 case.
1. With all the req uir ed scre ws rem ove d, lif t up
the bottom piece carefully.
Networked Media Tank
RoHS
Step 8
Applying thermal rubber to case.
(require Thermal Rubber 27x27x1.6mm packet)
1. Rem ove th erma l r ubbe r f rom pac ket, peel of f
protective transparent seal from both side.
2. Apply it to the case as shown above.
0006DC807015
412000800075
QC
Pass
QC
Pass
0006DC807015
412000800075
JAPAN
back
front
6
RoHS
side
rear
Y
Pb
Pr
COMPONENT VIDEO
CVBS
AUDIO OUT
COAX
OPTICAL
R
L
S/PDIF
S-VIDEO
USB-PC
USB
HDMI
ETHERNET
ACT LNK
POWER
What you need:
1. Popcorn Hour A-200
2. Popcorn Hour A-210 case
3. Philips head screw driver
4. Long nose Plier
Found in contents of A-210 case upgrade kit
1. Heat-sink
2. Thermal Rubber 50x50x2.6mm
3. Thermal Rubber 27x27x2.8mm
4. Thermal Rubber 27x27x1.6mm
5. LED Guide
6. PCB Spacer
7. Screws for LED Guide
8. Screws for PCB Spacer
9. Screws for heat-sink
Popcorn Hour A-210 case
Popcorn Hour A-200
Philips head screw driver
Long nose Plier
Thermal Rubber
LED Guide PCB SpacerHeat-sink Screws

Other manuals for POPCORN HOUR A-210

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the POPCORN HOUR A-210 and is the answer not in the manual?

POPCORN HOUR A-210 Specifications

General IconGeneral
BrandPOPCORN HOUR
ModelA-210
CategoryMedia Player
LanguageEnglish

Related product manuals