How to fix Popodusche Eco 2.0 Toilets electronic bidet that cannot work?
If your Popodusche Toilets' electronic bidet isn't working, first ensure the power is on. Then, check that the inlet water valve is open and that there is a water supply. Finally, make sure you are properly seated on the seat and adjust your sitting position.
Why does the nozzle go back suddenly after washing with Popodusche Toilets?
If the nozzle of your Popodusche Toilets goes back suddenly after washing for 3 minutes, it's likely normal. Simply return the knob to start washing again. However, also check if there are any water supply issues and ensure you are seated properly and adjust your sitting position.
What to do if night light is always on on Popodusche Eco 2.0 Toilets?
If the night light on your Popodusche Toilets is always on, try cleaning any obstructions around the knob. If that doesn't work, adjust the night light mode according to the "Light Setting" instructions.
Why is the water flow rate low on my Popodusche Toilets?
If you are experiencing low water flow rate with your Popodusche Toilets, it might be due to low water supply pressure. Try increasing the flow rate as described in the "adjusting water flow rate" section of the operating instructions. Also, verify that the water supply pressure is at least 0.07Mpa.
What to do if the water temperature is too high on Popodusche Eco 2.0 Toilets?
If you find that the water temperature is too high on your Popodusche Toilets, immediately shut off both the power and water supply. Stop using the product and contact your local distributor for assistance.
How to increase the water temperature on Popodusche Eco 2.0?
If you are experiencing low water temperature with your Popodusche Toilets, set the water temperature to a higher grade by following the "adjusting temperature" instructions.
Why does the nozzle go back automatically when manual cleaning Popodusche Eco 2.0?
To resolve the issue where the nozzle goes back automatically during manual cleaning of your Popodusche Toilets, ensure that you do not put the seat down while cleaning.
How to fix night light that cannot work on Popodusche Eco 2.0 Toilets?
If the night light on your Popodusche Toilets isn't working, activate the night light function and adjust the night light mode by referring to the "Light Setting" instructions.
What to do if something is wrong with Popodusche Toilets?
If there seems to be something wrong with your Popodusche Toilets, first, check if the power and water supply are functioning normally. Then, cut off the power for one minute and restart the product. If it still doesn't work, contact your local distributor.
Details on Rear Wash, Lady Wash, and water/stream settings.
Information on self-cleaning jet, nightlight, ambient light, and seat features.
Specifications for water flow, temperature, wash cycle, and heating.
How to activate and control Rear Wash and Lady Wash functions.
Guide to increasing or decreasing water flow rate via the control knob.
Instructions for moving the bidet nozzle forward or backward.
Steps to set the desired water temperature using the control knob.
How to adjust the night light for different modes (out, always on, smart).
Instructions for controlling the ambient light via the control knob.
Procedure to enter and exit the power standby mode.
Steps for manual cleaning of the nozzle using water.
Details on the automatic self-cleaning function for the tank.
General| Brand | Popodusche |
|---|---|
| Model | Eco 2.0 |
| Category | Toilets |
| Language | English |
To Next Page