Popp POPE005206 - User Manual

POPE005206
Weather Station
Firmware Version :1.0
Quick Start
A This is a Z-Wave actuator.
Inclusion and exclusion are performed by clicking the button on the back of the device three times. This
button can also be used to wake up the device. This device supports a secure connections via Z-Wave Plus.
Please refer to the chapters below for detailed information about all aspects of the products usage.
What is Z-Wave?
This device is equipped with wireless communication complying to the Z-Wave standard. Z-Wave is the
international standard for wireless communication in smart homes and buildings. It is using the frequency of
868.42 MHz to realize a very stable and secure communication. Each message is reconfirmed (two-way
communication) and every mains powered node can act as a repeater for other nodes (meshed network) in
case the receiver is not in direct wireless range of the transmitter.
Z-Wave differentiates between Controllers and Slaves. Slaves are either sensors (S) transmitting metered or
measured data or actuators (A) capable to execute an action. Controllers are either static mains powered
controllers (C) also referred to as gateways or mobile battery operated remote controls (R). This results in a
number of possible communication patterns within a Z-Wave network that are partly or completely supported
by a specific device.
1. Controllers control actuators
2. Actuators report change of status back to controller
3. Sensors report change of status of measured values to
controller
4. Sensors directly control actuators
5. Actuators control other actuators
6. Remote controls send signals to static controllers to
trigger scenes or other actions
7. Remote controls control other actuators.
There are two different role a controller can have. There is always one single primary controller that is managing the network and
including/excluding devices. The controller may have other functions - like control buttons - as well. All other controllers don't
manage the network itself but can control other devices. They are called secondary controllers. The image also shows that its not

Summary

Quick Start

Inclusion and Exclusion Process

Process for adding or removing the device from a Z-Wave network via button clicks.

Installation Guidelines

Optimal Device Placement

Recommends installing with solar panel facing sun and ensuring range to the main controller.

Behavior within the Z-Wave network

Joining and Leaving Networks

Describes the device's need to join an existing network (Inclusion) and leave (Exclusion).

Associations

Association Groups Explained

Details how devices control others via association groups and specific triggers like wind speed or light.

Command Classes

Supported Z-Wave Commands

Controlled Z-Wave Commands

Technical Data

Device Specifications Summary

Popp POPE005206 Specifications

General

Brand	Popp
Model	POPE005206
Category	Weather Station
Temperature Measurement	Yes
Humidity Measurement	Yes
Rain Gauge	Yes
Wind Speed Measurement	Yes
Wind Direction Measurement	Yes
Wireless Connectivity	Z-Wave
Power Supply	Battery
Battery Type	2 x AA
Radio Frequency	868.42 MHz
Range (Indoors)	Up to 30m
Range (Outdoors)	Up to 100m
IP Class	IP44
Display	No
Humidity Measurement Range	0% to 99%
Compatibility	Z-Wave